Rev.AKG-27.05.2025

Article is intended for

Reseller
Installer

Introduction

ST241 for Steplock comes preconfigured with all settings needed to use it with our cloud devices.
You will be asked to input the Modem serial number when you add your Intercom or Accesscontroller to the Cloud.

Packing

The package should include following products.

RUT241 Modem + Antennas	Ethernet Patch cable

Power cable	Wall mount

Installation

Mounting

Secure the holder to the flat surface with the 2 scews provided in the kit.

Insert the compatible device in the holder by press the serrated surface of the holder and push the device into place.

To release the device gently press the serrated surface of the holder.

Powering device

The ST241 device is powered directly by the power supply that supplying ST2029-POE, ST2043-POE, ST2042-POE

To install the modem take the power cable supplied in the box and connect it to the power input on the modem
marked as number 1 on the picture below.

Refer to the image below for the power socket's pinout information:

No	Description	Wire color
1	Power	Red
2	Ground	Black

Connect to ST2029-POE

Take the power cable and insert it into the ST2029-POE box, connect the red cable to +

and the black cable to the - on J10 connector.

The modem should start up as soon you connect the terminal to J10.

Now we need to connect the ST2029-POE to the network given by the modem,

take the supplied ethernet patch cable and connect it to the inlett marked as 2 in the picture.

In the other end connect the ethernet patch cable to the J7 ehternet connector.

Now is the connection of the modem ready.

Connect to ST2043-POE

Take the power cable and insert it into the ST2043-POE box, connect the red cable to +

and the black cable to the - on U6 connector.

The modem should start up as soon you connect the terminal to U6.

Now we need to connect the ST2043-POE to the network given by the modem,